The A is a sophisticated microprocessor controlled dual channel power meter which can measure ratio and A HP Manual was downloaded from the Web. HP A Power Meter is a dual channel power meter designed specifically for ATE systems. The compact front panel is designed to save space in rack mounted. The HP A Power Meter is a dual channel power meter designed specifically for ATE systems. . Option Additional manual. Option W Two additional.
|Published (Last):||21 December 2015|
|PDF File Size:||6.81 Mb|
|ePub File Size:||17.2 Mb|
|Price:||Free* [*Free Regsitration Required]|
View Cart My Account.
A HP Manual was downloaded from the Web. The A needs powering up occasionally to recharge the battery. Top view with cover removed.
Recommended for use with the Series Power Sensors. It measures absolute power in Watts or dBm, and relative power in dB.
November Checking all the specialist batteries in my test equipment, see Batteries In Test Equipment. Switch off Power Ref, check Oscillator light is off. Rear Panel Sensor Connector and additional reference oscillator with rear panel output. Welcome to Azur Electronics. The AUTO filter mode is usually adequate for fully settled readings with 0. Up to 19 different operating states of the meter can be stored into non-volatile memory for later recall.
Initial power up display. Compatible with the HP series of thermocouple and diode sensors, the power and frequency range of the meter extends from dBm to 44 dBm and from kHz to 50 GHz.
The A is a sophisticated microprocessor controlled dual channel power meter which can measure ratio and difference of power levels from 2 different sources. Up to 19 different operating states of the meter can be stored into non-volatile memory for later recall. The programmable digital averaging filter gives the user control over the inherent tradeoff between speed and accuracy. Less digital averaging leads to faster but noisier readings if speed is the critical issue. All measurement modes are programmable including zeroing, calibration, and Cal Factor.
The A has a 3V 0. Important measurement contributions are a programmable digital filter for optimizing resolution and measurement speed, independent offset in dB values for each channel, 0. Complete interrupt capability with flexible SRQ operation optimizes the efficiency of program execution in automatic systems. Top PCB hinges up.
Display with no sensors connected. The power reference output and calibration controls are used to calibrate the particular power sensor in use. Disconnect Sensor from Power Ref output. The compact front panel is designed to save space in rack mounted systems, while the dual channel design allows simple measurements of the ratio and difference of power levels from two separate sensors. January A Quick Calibration Procedure: Press Zero key and wait for routine.
Bottom view with cover removed. Initial display lights all segments. The battery maintains the supply voltage to the RAM. I use this as my ‘reference’ power meter.